superbrightleds EPLL Series User Manual

Important: Read all instructions prior to installation.
Linear Explosion Proof Light
EPLL-50K40-UGN-110
Specifications
Model EPLL
Operating Temperature
IP Rating
Fixture Weight
Wiring Diagram
Line
Neutral
Ground
Dim (+)
Yoke Mount Installation (Included)
Dim (-)
1. Attach mount to light.
2. Drill 10 mm mounting holes 170 mm apart.
3. Hammer in mounting bolts into ceiling.
4. Fasten yoke mount/light assembly to mounting bolts until secure.
5. With supply power off, open driver box and connect wiring.
6. Rotate light to desired angle and tighten adjustment screw.
Ø10 mm
Ø170 mm
5yr
Safety and Notes
• Product should be installed by a certified electrician in accordance with applicable national,
state, and local building and electrical codes. Proper earth grounding is required.
• To reduce the risk of electric shock, ensure that the main power source and circuit breakers
are switched off before performing any installation or wiring procedures. If smoke is detected
or a short circuit is present, switch off power immediately and notify relevant personnel.
• Avoid looking directly into the light when illuminated.
• Failure to properly support the fixture may result in damage or injury, for which the manufacturer
does not assume responsibility. Check whether any accessories are correctly installed
prior to installation.
• If the light is damaged during shipping, do not install and contact customer service immediately.
-xK40-UGN-110 -xK80-UGN-110
-40°–122° F(-40°–50° C)
IP66
16.9 lb (7.7 kg) 25.5 lb (11.6 kg)
Black
L L
White
N N
Green
GND GND
Purple
+ +
Gray
- -
-xK120-UGN-110
Line
L L
Neutral
N N
26.1 lb (11.8 kg)
Ground
GND GND
Dim (+)
+ +
Dim (-)
- -
Conduit Installation
Rev Date: V1.1 06/29/2020
4400 Earth City Expy, St. Louis, MO 63045
User Manual
EPLL Series
Check product label for specific electrical
Black
specifications related to installation.
Improper installation will void warranty.
White
Green
Purple
Gray
866-590-3533 superbrightleds.com