Analog Output - Delta DPA Series Instruction Sheet

 In the "Measuring Mode", press
Lo). Use to set up Hi/Lo values.
3. Window Mode: Set up pressure Hi/Lo. When the pressure measured is bigger than Hi or smaller than Lo, the output will be OFF. When the
pressure measured is bigger than Lo and smaller than Hi, the output will be ON. (See Figure 3: Output in Window Mode)
 In the "Measuring Mode", press
Lo). Use to set up Hi/Lo values.
 In the "Advanced Setup Mode", press

Note: Supposed the output is ON and the output status is set to N.O. (normally open), the output will then be off. If the output status is set
to N.C (normally closed), the output will then be on. Supposed the output is OFF and the output status is set to N.O., the output will then be on.
If the output status is set to N.C., the output will then be off.
 Zero Returning
In the "Measuring Mode", press
returning.
 Analog Output
When the input pressure starts to change, the analog output will change with the input. For example, supposed the range for input is -100kPa
~ 100kPa, and DPA reads -100kPa, the output will be 4mA or 1V. When DPA reads 100kPa, the output will be 20mA or 5V. (See Figure 4:

Analog Output)

and find (OUT1 Hi),
[Figure 2: Output in Hysteresis Mode]
and find (OUT1 Hi),
and find . Use
[Figure 3: Output in Window Mode]
together, and you will see
[Figure 4: Analog Output]
- 6 -
(OUT1 Lo),
(OUT1 Lo),
to set up "dP" value.
. The zero returning will start. Release the keys to end the zero
(OUT2 Hi) and (OUT2
(OUT2 Hi) and (OUT2