Figure 86. Removing a power supply unit from Front Accessed configuration
Next steps
Replace the PSU
or
replace the PSU
Installing a power supply unit
Prerequisites
1. Follow the safety guidelines listed in the
2. For systems that support redundant Power Supply Units (PSUs), ensure that both the PSUs are of the same type and have
the same maximum output power.
NOTE:
The maximum output power (shown in watts) is listed on the PSU label.
3.
Remove the PSU blank.
NOTE:
The PowerEdge XR11 has two types of Power Supply Units (PSUs). The PSUs with black straps are designed for
Rear Accessed configuration while the PSUs with blue straps are designed for Front Accessed configuration.
Steps
Slide the PSU into the PSU bay until the release latch snaps into place.
88
Installing and removing system components
blank.
Safety
instructions.