Installing The Expansion Card Risers - Dell EMC PowerEdge XR11 Installation And Service Manual

Figure 62. Removing Riser 2 and 3
Next steps
Replace the expansion card

Installing the expansion card risers

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If removed, install the expansion cards into the expansion card risers and connect all the riser cables.
NOTE: The procedure to install the expansion card risers is the same for Rear Accessed and Front Accessed configurations.
Steps
1. For Riser 1, hold the blue touch points aligning the expansion card riser with the connector on the system board and the riser
guide pins on the system chassis.
72 Installing and removing system components
riser.
Safety instructions.
Before working inside your system.