Internal Storage Configuration Matrix For Xr11 - Dell EMC PowerEdge XR11 Installation And Service Manual

Figure 38. Installing the drive backplane
Next steps
1. Connect the cables to the backplane and then verify that both power and signal cable connections are fully seated to the
backplane and system board.
2. Install all the drives.
3. Install the PCI air shroud.
4. Follow the procedure listed in

Internal storage configuration matrix for XR11

Table 14. Internal storage configuration matrix
Configu Chassis
ration orientation
1 Front
Accessed
2 Front
Accessed
3 Front
Accessed
4 Front
Accessed
5 Front
Accessed
6 Front
Accessed
7 Rear
Accessed
8 Rear
Accessed
After working inside your
Base configuration Backplane
description description
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 NVMe (only)
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 NVMe (only)
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 SAS/SATA
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 SAS/SATA
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 SAS/SATA
ASSY, CHAS, RAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 SATA (only)
ASSY, CHAS, NAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 NVMe (only)
ASSY, CHAS, NAF, 4 x 2.5-inch
4HD, 3PCI, 1U, XR11 NVMe (only)
system.
Storage Controller
controller(s) form factor
H755 Adapter
S150 Direct Attach
(SL)
H345 Adapter
H755 Adapter
HBA355i Adapter
Onboard Onboard
SATA SATA
H755 Adapter
S150 Direct attach
(SL)
Installing and removing system components
BOSS Riser
enabled configuration
Y C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
Y
C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
Y C0/1: R1B+R2+R3
49