Dell EMC PowerEdge XR11 Installation And Service Manual page 94

Figure 93. System board screw fastening sequence
Next steps
1. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
brackets.
2. Replace the following components:
a. Trusted Platform Module (TPM)
NOTE: The TPM Module must be replaced only while installing a new system board.
b. Internal USB memory key (if installed)
c. Processor and heat sink module
d. BOSS S1 card
e. Memory modules
f. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable
securing brackets.
g. Expansion card riser 1
h. Expansion card riser 2 and 3
i. Air shrouds
j. System cover
3. Ensure that you perform the following steps:
a. Use the Easy Restore feature to restore the Service Tag. See the
feature section.
b. If the service tag is not backed up in the backup flash device, enter the system service tag manually. See the
update the Service Tag by using System Setup
c. Update the BIOS and iDRAC versions.
Re-enable the Trusted Platform Module (TPM). See the
4. If you are not using Easy Restore, import your new or existing iDRAC Enterprise license. For more information, see the
iDRAC User's Guide available at
5. Follow the procedure listed in
Restoring the system using Easy Restore
The Easy Restore feature enables you to restore your service tag, license, UEFI configuration, and the system configuration data
after replacing the system board. All data is backed up in a backup flash device automatically. If BIOS detects a new system
board, and the service tag in the backup flash device, BIOS prompts the user to restore the backup information.
94 Installing and removing system components
section.
https://www.dell.com/idracmanuals
After working inside your
Restoring the system by using the Easy Restore
Upgrading the Trusted Platform Module
.
system.
Manually
section.