Section Three: Calibrated Leak Replacement for G8610, G8611, or G8612
Equipment Required
•
Slotted Screw Driver
Installation Procedure
For clarity, some items have been omitted from views.
WARNING
1. Turn off the power switch located on the back of the unit and unplug.
2. Wait 30 seconds for the high voltage to dissipate.
3. Using a slotted screw driver, unfasten the four screws holding the rear cover (Figure 1: Rear Cover Screws) and
detach the rear cover from the unit.
Calibrated Leak Replacement for VS C15, VS, and (G8610, G8611, or G8612) Series Leak Detectors
Figure 1: Rear Cover Screws
Disconnect power from the unit before performing any maintenance procedure that
requires physically disconnecting any part of the system.
Page 10 of 12
Document No.
Revision
699909998
C