Electric Connections - Baumatic BF13 Instruction Manual

Applying the seal
Important - The figure below shows how the seal must be attached all around the perimeter.
This cook top has been designed for non-professional, domestic use.

2. Electric connections

Check the details given on the nameplate situated on the underside of the cook top, then make sure that the rated mains
voltage and power available are suitable for its operation.
Before making the electric connections, check the efficiency of the earthing system. Earthing of the cook top is
compulsory by law. The manufacturer will accept no liability for any personal injury or damage to property deriving from
failure to comply with this requirement.
Make a fixed connection to the mains, connecting the hob to an all-pole circuit breaker with a breaking gap of at least 3
mm between the cook top and the mains.
To connect the cook top power cord, loosen and remove the cover on the terminal block in order to access the contacts
inside. Make the connection, blocking the cord in place with the cable clamp provided and then close the terminal block
cover again immediately. You must make sure that the links are connected as shown in the wiring diagram below.
If you have to change the cord, the earthing (yellow / green) conductor must always be 10 mm longer than the line
conductors.
DECLARATION OF CONFORMITY. In the parts destined to come into contact with foodstuffs, this appliance is in
accordance with the requirements of the EC directive 89/109 transposed in the Italian Legislative Decree N° 108 of
25/01/92.
CE Appliance conforming to the European directives 89/336/EEC, 93/68/EEC, 73/23/EEC and subsequent revisions.
NOTE
The appliance must NOT be connected to the
mains supply by means of a 13A plug and
socket and must be hard wired using 30A cable.
SERVICING
During the guarantee period, all service intervention
should be referred back to the Baumatic Ltd Service department.
Please note that intervention or repair by any
unauthorized personnel will invalidate such guarantee.
IMPORTANT: If only two of the zones operate, then check the links
in the terminal block again, making sure that they are fully tightened.
6