Split Design; Separating The Gun; Joining The Gun - WAGNER FineCoat Split-Gun Operating Manual

3.

Split design

This HVLP spray gun has a split-gun design that allows for easier
cleaning and disassembly. The two sections are the gun head (Fig. 2,
item 1) and gun rear (2).
2
3.1

Separating the gun

1. Make sure the air hose is removed from the air inlet of the
spray gun.
2. Swivel the trigger releases on both sides of the spray gun so
they are pointing up (fig. 3, item 1).
3. Push the lever toward the rear of the gun to unlock the two
gun halves (fig. 3, item 2).
1
4. While looking at the rear of the spray gun, turn the gun rear
counterclockwise to remove it from the gun head.
i
The needle (fig. 4, item 1) will remain inside the gun
head. Be sure not to remove unless instructed.
FineCoat Split-Gun
GB
3.2
1
2
1
17

Joining the gun

1. Make sure the trigger releases on both sides of the spray gun
are pointing up (toward the gun hook).
2. With the gun rear oriented upside down, bring the two halves
together. While looking at the rear of the spray gun, turn the
trigger section clockwise until it snaps back into place with the
gun head.
3. Swivel the trigger releases on both sides of the spray gun so
that they are pointing toward the gun head.
Split design