Spraying Technique; Breaks In Work - WAGNER FineCoat Split-Gun Operating Manual

Starting operation
Setting the amount of air (fig. 13)
The correct setting for the amount of air is decisive for the
atomization and formation of paint mist.
Maximum Minimum
+
Setting the ascending feed pipe
Spraying object lying on floor (fig. 14)
Turn rotating lever clockwise as far as it will go.
Spraying object over head (fig. 15)
Turn rotating lever anti-clockwise as far as it will go.
-
GB
7.

Spraying technique

Hold the paint spray gun upright and maintain a constant distance of
about 3 - 20 cm to the object being sprayed.
Move the paint spray gun evenly either from side to side or up and
down. If the gun is moved evenly, it will produce an even surface
finish. No runs will occur if the speed is correct.
Always start spraying away from the object and avoid stopping
spraying whilst still on the object.
i
If the round jet setting is used, the distance may be
increased according to the size of the object being
sprayed.
• In case of excessive paint mist formation, adjust the air
and material flow respectively and alter the distance from
the object.
Right
3 - 20 cm
Wrong
Excessive paint mist formation, uneven surface finish.
7.1

Breaks in work

1. Turn the material regulating knob to the right as far as it will
go (fig. 18).
This will secure the paint spray gun against unintentional
operation.
2. Switch the unit off.
20
Spraying technique
FineCoat Split-Gun