Advertisement
Available languages
Available languages
5. Setup & Operation
Never switch on the water heater without water. Before switching on, open the hot water taps, vent the pipes of air
and fill the appliance.
Check the water tightness of the pipe work and the door seal below the cover. In case of a leak, tighten slightly. Check
that the water safety devices are working and fill the drain. Switch on the appliance. After 5 – 20 minutes, depending
on the capacity of the appliance, water should drip from the drain hole. This phenomenon is due to water
expansion and is normal. Check the water tightness of the joints and the seal. During heating and depending on water
quality, room-sealed water heaters can produce a boiling noise; this is normal and does not indicate any defect on the
appliance. To avoid the development of bacteria (legionella...) ensure that a temperature of 60°C is reached every day.
The thermostat is set at the factory at the stop (65°C+- 5°C).
If steam or boiling water emerges continuously from a supply tap or a drain valve, switch off the electricity to
the water heater or boiler and call a professional plumbing contractor
6. Maintenance
User maintenance: Operates once a month the discharge of the water safety device to prevent scaling and
verify that it is not blocked. If this is not done, damage may be caused and the guarantee invalidated. .
Maintenance by a qualified person:
6.1 Remove the scale sludge. Do not scrape or hammer the lime scale deposited on the casing, as this may damage the
lining.
6.2 Change the magnesium anode every 2 years or when its diameter is lower than 10 mm.
6.3 Changing the shielded heating element or the anode requires the water heater to be drained and the joint changed.
DRAIN: Switch off the power and cold water and open the hot water taps before carrying out these operations. Refit the
heating element and tighten the screws smoothly (opposite screws in sequence), check for leaks the next day and
tighten if required. If the supply cord is damaged, it must be replaced by a special cord or assembly available from the
manufacturer or its service agent.
Replaceable parts: the thermostat, seals, heating element, the heating sleeve, the indicator light, the magnesium
anode, the connection cable. The guarantee requires genuine manufacturer's parts to be used.
6. Guarantee
The water heater must be installed, used and maintained according to best practice and conform to the standards in
force in the country in which it is installed and to the instructions contained in this document. In the European Union
this appliance is covered by the statutory guarantee accorded to consumers in accordance with directive 1999/44/CE.
This guarantee comes into force when the appliance is delivered to the consumer. In addition to the legal guarantee,
certain items are covered by an extra guarantee relating only to the free exchange of the tank and of components
accepted as defective. It does not include the cost of replacement or carriage. Refer to the table below. This
commercial guarantee does not affect your statutory rights. It applies within the country where the product was
acquired, provided it is also installed in the same country. The dealer must be informed of any damage before the
product is exchanged under guarantee and the appliance will remain available for inspection by experts from the
insurance company and the manufacturer.
Range
Statutory
Extra commercial guarantee on tanks and the
sleeve for "STEATITE" except for electrical
components
To claim under guarantee, contact your installer or dealer. If necessary, contact: ATL INTERNATIONAL
Tel.:(33)146836000, Fax (33)146836001 58 av Gén. Leclerc 92340 Bourg-la-Reine (France) who will inform you of
what you should do. The guarantee applies only to examined products which are accepted as faulty by the
company underwriting the guarantee. It is essential that products should be retained for inspection by them.
Exclusions: Wear parts: magnesium anodes....Equipment which cannot be assessed (access difficult for repair,
maintenance or assessment). Equipment exposed to abnormal environmental conditions: frost, bad weather,
water which is abnormally aggressive or outside drinking standards, electrical supply with large spikes. Equipment
installed without observing current standards in the country of installation: the absence or incorrect fitting of safety
devices, abnormal corrosion due to incorrect water fitments (iron/copper contact), incorrect earthing, inadequate
cable thickness, non-observance of the connection drawings shown in these instructions. Equipment not
maintained in accordance with these instructions. Repairs or replacement of parts or components in the equipment
not carried out or authorised by the company responsible for the guarantee. Changing a component does not
extend the life of the guarantee.
14
To reduce the risk of excessive pressures and temperatures in this water heater, install temperature and
pressure protective equipment supplied with the water heater (pressure relief devices). Install the valve
into an opening provided for this purpose in the water heater, and orient it or provide tubing so that any
discharge from the valve will exit only within 15 cm above or at any distance below the structural floor and
cannot contact any live electrical part. The discharge opening must not block or reduce in size under any
circumstances.
SQUARE O'PRO
2 years all parts
+ 1 year (For Ireland : + 0
year)
12
SQUARE CERAMIC
2 years all parts
+ 3
years (For Ireland : +
0 year)
Advertisement
