Safety Guidelines - ADJ PAR Z MOVE RGBW User Instructions

S A F E T Y G U I D E L I N E S
To guarantee a smooth operation, it is important to follow all instructions and guidelines in this manual.
ADJ Products, LLC is not responsible for injury and/or damages resulting from the misuse of this fixture
due to the disregard of the information printed in this manual. Only qualified and/or certified personnel
should perform installation of this fixture and only the original rigging parts included with this fixture
should be used for installation. Any modifications to the fixture and/or the included mounting hardware
will void the original manufactures warranty and increase the risk of damage and/or personal injury.
PROTECTION CLASS 1 - FIXTURE MUST BE PROPERLY GROUNDED
THERE ARE NO USER SERVICEABLE PARTS INSIDE THIS UNIT. DO NOT ATTEMPT
ANY REPAIRS YOURSELF; DOING SO WILL VOID YOUR MANUFACTURES WARRANTY.
DAMAGES RESULTING FROM MODIFICATIONS TO THIS FIXTURE AND/OR THE
DISREGARD OF SAFETY INSTRUCTIONS AND GUIDELINES IN THIS MANUAL VOID
THE MANUFACTURES WARRANTY AND ARE NOT SUBJECT TO ANY WARRANTY
CLAIMS AND/OR REPAIRS.
DO NOT PLUG FIXTURE INTO A DIMMER PACK!
NEVER OPEN THIS FIXTURE WHILE IN USE!
UNPLUG POWER BEFORE SERVICING FIXTURE!
NEVER TOUCH FIXTURE DURING OPERATION AS IT MAY BE HOT!
Maximum ambient temperature is Ta: 40°C. DO NOT operate it where the temperature
is higher than this. Unit surface temperature may reach up to 75°C. DO NOT touch
the housing bare-hand during its operation. Turn off the power and allow about 15
minutes for the unit to cool down before replacing or serving.
KEEP FLAMMABLE MATERIALS AWAY FROM FIXTURE!
ENSURE ALL CONNECTIONS AND END CAPS ARE PROPERLY SEALED WITH A
DIELECTRIC GREASE (AVAILABLE AT MOST ELECTRICAL SUPPLIERS) TO PREVENT
WATER CORROSION AND/OR ELECTRICAL SHORT CIRCUIT.
IF THE FIXTURE IS EXPOSED TO ENVIRONMENTAL TEMPERATURE CHANGES SUCH
AS RELOCATION FROM AN OUTDOOR COLD TO AN INDOOR WARM ENVIRONMENT,
DO NOT POWER THE FIXTURE ON IMMEDIATELY. INTERNAL CONDENSATION AS
A RESULT OF ENVIRONMENTAL TEMPERATURE CHANGE CAN CAUSE INTERNAL
FIXTURE DAMAGE. LEAVE THE FIXTURE POWERED OFF UNTIL IT HAS REACHED
ROOM TEMPERATURE BEFORE POWERING ON.
NEVER LOOK DIRECTLY INTO THE LIGHT SOURCE! RETINA INJURY RISK - MAY
INDUCE BLINDNESS! SENSITIVE PERSONS MAY SUFFER AN EPILEPTIC SHOCK!
THIS IS A RISK GROUP 3 (HIGH RISK) PRODUCT ACCORDING TO EN 62471 AND IEC/
TR 62778. THE LUMINAIRE SHOULD BE POSITIONED 63 METERS OR MORE FROM
THE OUTPUT OF THE FIXTURE TO REDUCE OR ELIMINATE EXPOSURE.
6