Touchscreen Control Quick Start - Pentair FLECK 5810 Service Manual

TOUCHSCREEN CONTROL QUICK START

The XTR2 control was designed to be easy to set up and begin
using right out of the box. The following simple procedure can
be used to set up the system and begin treating water in most
typical applications.
NOTE: Steps 3 and 4 are optional and are not required to start
the system. All control settings may be changed after
the unit is in service.
NOTE: Press on any Quick Start screen to reset the screen
back to its default settings.
1. After plugging in the unit, the Format screen (Figure 3) is
displayed.
Figure 3 Format Screen
Press the language button to adjust the system's displayed
language (international version only): English, French,
German, Italian, or Spanish. Press
Press the units button to adjust the system's units of
measure (either U.S. or metric). Press
Press the hardness units button to adjust the system's
hardness units of measure (grains per gallon, mg/L or ppm,
German degrees, French degrees, or English degrees).
Press when finished. Hardness units are adjustable only
if metric units are selected.
NOTE: If the screen is blank after plugging in the unit, touch
the screen to turn the screen on.
2. After pressing , the Assistance Name screen (Figure 4) is
displayed.
Figure 4 Assistance Name Screen
3. After pressing
4. After pressing
when finished.
when finished.
Using the keypad, type the name of the water treatment
professional or company that the homeowner may call for
system service (optional).
To enter a letter using the keypad, quickly press the keypad
button the number of times that correspond with the
position of the correct letter on the button. For example,
to enter the letter "C", quickly press the ABC button three
times. Press when finished.
, the Assistance Phone screen (Figure 5)
is displayed.
Figure 5 Assistance Phone Screen
Enter the phone number of the water treatment
professional or company that the homeowner may call for
system service (optional). Press
, the Assistance Interval screen (Figure 6)
is displayed.
Figure 6 Assistance Interval Screen
Use the Assistance Interval screen to set the interval in
which the homeowner will need to call a water treatment
professional for system service (optional). The assistance
interval can be based on a set number of months (month
based) or a number of regenerations (regen based).
Press the interval button to select a month-based or regen-
based assistance interval, then press
the month or regen button (depending on your previous
selection), and select the number of months (up to 60) or
regenerations (up to 2000) until the homeowner will need to
call for service. Press when finished.
FLECK 5810 & 5812 XTR2 Service Manual • 5
when finished.
. Press either