Pentair FLECK 5810 Service Manual page 14

MASTER SETTINGS PROGRAMMING
continued
Non-Factory Settings
After all parameters in Master Programming have been set,
these settings can be saved to a custom profile by pressing
on the main Master Settings screen (see Figure 17 Master
Settings Screen). After pressing
screen appears.
Figure 27 Non-Factory Settings Screen
Press to save all programmed Master Settings parameters
to non-factory settings. At any point, the control can be reset
to these saved custom settings (see "MASTER RESET" on
page 16). By performing a custom reset, any setting that
is subsequently programmed without saving to non-factory
settings will be reset to the previously saved non-factory
settings in the control.
Diagnostics
The control records and displays a variety of diagnostic data to
assist with troubleshooting performance issues and fine-tuning
system efficiency. Press the Diagnostics button
Master Settings or Home screens to view the Diagnostic
screen.
Figure 28 Diagnostic Screen
14 • FLECK 5810 & 5812 XTR2 Service Manual
, the Non-Factory Settings
from the
• Press the screen navigation arrows at the upper-right and
left of the screen to view each diagnostic parameter.
• Press the Home button
NOTE: If a regeneration occurs while in the Diagnostic screen,
the unit will return to the main screen.
Parameter
Flow Rate
Peak Flow Displays maximum flow rate of water along
with date and time of occurrence, since last
Totalizer Displays total volume of water used since
Last Regen Displays when last regeneration occurred.
Reserve Displays the reserve volume based on the
reserve type selected under master settings.
*This parameter is only available for meter
Software Ver Displays the software version installed on
No of Regens Displays how many manually and system
initiated regenerations the system has gone
Regen Interval Displays the average length of time between
regenerations based on the past four
Daily Usage Displays average water usage for each day of
the week based on the usage on that day for
Usage Since Regen Displays water usage since last regeneration.
Last Setting Change Displays the date and time of the last update
NOTE: Only Peak Flow and Totalizer can be changed - they
can be reset to zero.
NOTE: Totalizer has a maximum value of 99,999,999. If this
number is reached, the Totalizer must be reset to zero
to continue tracking this value.
to return to the Home screen.
Description
Displays the current flow rate.
reset.
last reset.
delayed regeneration type.
the controller.
through since last reset.
regenerations.
the past six weeks.
to Master Settings.