Zero Touch Cloud Service - Check Point QUANTUM SPARK 1570 Getting Started Manual

Zero Touch Cloud Service

The Zero Touch Cloud Service lets you easily manage the initial deployment of your gateways in the
Touch portal
.
Zero Touch enables a gateway to automatically fetch settings from the cloud when it is connected to the
internet for the first time.
Note - If you already used the First Time Configuration Wizard to configure your appliance, you cannot use
the Zero Touch Cloud service. If you start the First Time Configuration Wizard while the Zero Touch
settings are being installed, the installation process terminates.
If the gateway connects to the internet via DHCP, the gateway will fetch the Zero Touch settings without
any additional action. If no DHCP service is available, you must run the First Time Configuration Wizard,
configure the Internet Connection settings, and then fetch the settings from the Zero Touch server.
To connect to the Zero Touch server from the First Time Configuration Wizard:
1. In the Welcome
2. In the window that opens, click
3. The Internet connection
Internet connection and click
The settings are automatically downloaded and installed.
A new window opens and shows the installation status. It may take several minutes until the
installation is complete.
When you reconnect to the appliance WebUI or click
Login
page - This means the process ended successfully and your settings are installed.
n
Welcome page of the First Time Configuration Wizard - The process is still running. The settings
n
are installing or they do not exist in the cloud.
Note - If you click
terminates
Page not found
n
installation. Try http://my.firewall or consult your administrator for the new local IP address.
After the gateway downloads and successfully applies the settings, it does not connect to the Zero Touch
server again.
For more information on how to use Zero Touch, see
Admin Guide
.
Retries mechanism:
During cloud activation, there are sometimes temporary issues which prevent the gateway from activating
Cloud Services. See the
page of the First Time Configuration Wizard, click
Yes to confirm that you want to proceed.
page of the First Time Configuration Wizard opens. Configure your
Connect
.
Next Welcome
on the
- The appliance local IP address may have been changed by the cloud settings
Management LED description in the
Quantum Spark 1570 / 1590 Appliance R80.20.XX Getting Started Guide | 62
Refresh
, you may see one of these:
page, the Zero Touch settings installation process
sk116375 and the
"Front Panel" on page 22
Zero Touch Cloud Service
Fetch Settings from the cloud
R80.20 Zero Touch Web Portal
section.
Zero
.