Check Point QUANTUM SPARK 1570 Getting Started Manual page 40

To connect to the Zero Touch server:
1. In the Welcome
2. In the window that opens, click
3. The Internet connection
4. The Fetching settings from the cloud
provider
status. This process may take several minutes.
5. If you fail to connect, an error message appears. Possible errors include:
Internet connection is not configured correctly.
n
Internet connection is through a proxy server.
n
Zero Touch is already running.
n
Zero Touch service already completed.
n
The First Time Configuration Wizard already completed.
n
Zero Touch service is disabled.
n
Where applicable, click
6. After you connect to the server, the settings are automatically downloaded and installed. The status
is shown in the Fetching settings from the cloud
installation is complete.
7. Click Finish
.
Note - If a collision is detected between an internal network (LAN) and an IP returned using DHCP (WAN),
the conflicting LAN address is changed automatically. If a colliding LAN IP address is changed, a message
appears in the system logs.
When you reconnect to the WebUI or click
process.
After the gateway downloads and successfully applies the settings, it does not connect to the Zero Touch
server again.
Fetch Settings from the cloud
page, click
OK to confirm that you want to proceed.
page opens. Configure your Internet connection and click
window opens and shows the
Retry
now to connect again.
Refresh
Quantum Spark 1570 / 1590 Appliance R80.20.XX Getting Started Guide | 40
.
window. It may take several minutes until the
, the browser opens to show the status of the installation
Connect
Connecting to the service
Welcome
.