Security Management Server Connection - Check Point QUANTUM SPARK 1570 Getting Started Manual

Security Management Server Connection

For Centrally managed appliances only:
After you set a one-time password for the Security Management Server and the appliance, you can
connect to the Security Management Server to establish trust between the Security Management Server
and the appliance.
To connect to the Security Management Server, select one of these:
Connect to the Security Management Server now
n
Connect to the Security Management Server later
n
If you select to connect now, enter the data for these fields:
Management address
n
Connect
- When you successfully connect to the Security Management Server, the security policy
n
will automatically be fetched and installed.
If the Security Management Server is deployed behind a 3rd party NAT device, select
n
the above address to connect to the Security Management Server
address or the host name of the appliance should connect to reach the Security Management
Server.
If you enter an IP address, it will override the automatic mechanism that determines the routable
IP address of the Security Management Server for each appliance.
If you enter a host name, it is saved and the Security Gateway will re-resolve the name of the
IP address changes. This configuration can be edited later in the
page of the WebUI.
If you do not select this checkbox and you use a host name to fetch the policy, when the policy is
fetched, the Security Management Server IP is set to the IP address in the policy.
Select where to send logs:
Send logs to same address
l
the Security Management Server.
Send logs to
l
Send logs according to policy
l
are defined in the policy.
- Enter the IP address or host name of the Security Management Server.
- The logs are sent to the IP address entered on this page for
- Enter the IP address of a log server.
- The logs are sent according to the log server definitions that
Quantum Spark 1570 / 1590 Appliance R80.20.XX Getting Started Guide | 58
Security Management Server Connection
.
.
. Manually enter the IP
Home Security Management
>
Always use