Administrator Access - Check Point QUANTUM SPARK 1570 Getting Started Manual

Administrator Access

Administrator Access
In the
address or any IP address.
To configure administrator access:
1. Select the sources from where administrators are allowed access:
LAN
- All internal physical ports.
n
Trusted wireless
n
VPN - Using encrypted traffic through VPN tunnels from a remote site or using a remote
n
access client.
Internet
- Clear traffic from the Internet (not recommended).
n
2. Select the IP address from which the administrator can access the appliance:
Any IP address
n
Specified IP addresses only
n
from a specified IP address or network. Click
Specified IP addresses from the Internet and any IP address from other sources
n
this option to allow administrator access from the Internet from specific IP addresses only and
access from other selected sources from any IP address. This option is the default.
To specify IP addresses:
1. Click New .
2. In the IP Address Configuration window, select an option:
Specific IP address
n
Specific network
n
3. Click Apply
.
page, configure if administrators can use the appliance from a specified IP
- A known wireless network.
.
- Select this option to let administrators access the appliance
- Enter the IP address
Network IP
- Enter the
Quantum Spark 1570 / 1590 Appliance R80.20.XX Getting Started Guide | 52
New to configure the IP address information.
or click Get IP from my computer
Subnet mask
address and
Administrator Access
- Select
.
.