(2) Removing the ADF Document Size PCB UNIT
WARNING
● Always remove the power cord plug from
the outlet before replacing a PCB unit.
1. Remove the ADF feed shaft assy.
2. Remove the two screws to remove the ADF
feed inlet.
3. Remove the four screws to remove the Turn
guide.
4. Disconnect the connector.
5. Remove the two screws to remove the ADF
document size PCB unit.
→See Page 31
Chapter 3 3 Electrical System
Screw
Screw
Screw
Turn guide
Screw
ADF document size PCB unit
Screw
ADF feed inlet
Screw
3
Screw
Connector
Screw
37