5. Remove the two screws to remove the motor
bracket.
6. Remove the two screws to remove the ADF
stepping motor.
(11) Removing the ADF Document Lead Edge Sensor
1. Follow steps 1 to 4 in Removing the ADF
Document Jam Sensor.
2. Remove one screw to detach the ADF
document lead edge sensor together with the
bracket.
3. Disconnect the connector to remove the ADF
document lead edge sensor.
→See (6) above
Chapter 3 2 ADF Section
ADF Stepping Motor
Sponge
Screw
ADF Document Lead Edge Sensor
Screw
Motor Bracket
Screw
3
Connector
Bracket
Sensor
35