Removing The Timing Belt; Removing The Adf Clutch A/B - Ricoh ADF DF7010 Field Service Manual

(7) Removing the Timing Belt

1. Remove the ADF front cover.
2. Loosen the tension's fixing screw.
3. Pull the timing belt off the pulley, and remove
the timing belt.
Reinstallation
IMPORTANT
● Be sure to adjust the tension after installing
the Timing belt.

(8) Removing the ADF Clutch A/B

1. Remove the ADF document cover.
2. Remove the ADF rear cover.
3. Disconnect the two connectors.
4. Remove the screw to remove the angle.
5. Remove the ADF clutch A/B.
Reinstallation
IMPORTANT
● The ADF clutch A and ADF clutch B are not
the same type. Attach the correct one to
the correct position.
• ADF clutch A: 2-pin connector
• ADF clutch B: 3-pin connector
→See Page 27
→See Page 40
→See Page 24
→See Page 27
Chapter 3 2 ADF Section
Screw
Tension
Pulley
Pulley
Timing belt
Angle
ADF Clutch A
Connector
Connector
Pulley
３
Screw
Angle
ADF Clutch B
33