Badger Meter ER-10 Installation & Operation Manual
  1. Manuals
  2. Brands
  3. Badger Meter Manuals
  4. Measuring Instruments
  5. ER-10
  6. Installation & operation manual

Badger Meter ER-10 Installation & Operation Manual

Hide thumbs Also See for ER-10:
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
Installation &
Models ER-10 &
Digital Resettable Totalizers and
ER-10H
Digital Rate of Flow Indicators
Operation Manual
ER-10
ER-10H
(For Portable Large Meter Tester Only)
This Product Contains Lithium Batteries.
Read This Manual Before Attempting Any Installation,
Wiring Or Operation.
IOM-124-01
BadgerMeter, Inc.
Part No. 53400-124
10-05
®

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ER-10 and is the answer not in the manual?

Questions and answers

Related Manuals for Badger Meter ER-10

Summary of Contents for Badger Meter ER-10

  • Page 1 Installation & Models ER-10 & Digital Resettable Totalizers and ER-10H Digital Rate of Flow Indicators Operation Manual ER-10 ER-10H (For Portable Large Meter Tester Only) This Product Contains Lithium Batteries. Read This Manual Before Attempting Any Installation, Wiring Or Operation.
  • Page 2 Technical Support 1-800-456-5023 General Information The ER-10 and ER-10H are external or battery powered backlit by connecting an external DC (10-30 VDC) power electronic registers that display rate of flow and total flow. supply. A single unit can accept NPN or dry contact inputs They have independent programmable scale factors for for low or high speed applications.

  • Page 3: Installation

    Terminal – (1) Terminal + (2) PFT420/2 Pulse Output Pulse Output To connect a generic reed switch to the ER-10, connect Terminal – (1) Terminal + (2) one of the wires to terminal 1. Connect the remaining wire Black (1) Red (2) to terminal 2.

  • Page 4: Operation

    Operation By pressing the key during normal operation, the ER-10 will alternatively display the Flow Total or the Flow Rate. The Letter R on the left indicates that the Flow Rate is being displayed. Total Display: Indicates the present Reset Key:...

  • Page 5: Totalizer Programming

    ER-10/ER-10H Programming Calculations Before you program the Rate Scale Factor, you must set TOTALIZER PROGRAMMING the Rate Decimal Point position (Program Mode #4). This Totalizer values can be expressed in any engineering unit decimal point will correspond to the decimal in the Rate of measure such as gallons, quarts, liters, etc.

  • Page 6: Troubleshooting

    Troubleshooting PROBLEM POSSIBLE CAUSES REMEDIES Screen is blank 1. Battery is dead. 1. Replace battery. Will not count in totalizer mode 1. Improperly programmed. 1. Check programming. 2. Broken or defective wiring. 2. Check wiring. 3. Improperly connected. 3. Check connections. 4.
  • Page 7 INDUSTRIAL TURBO METER 3. Pull the reed switch pickup assembly and pad from 1. Remove the front cover on the ER-10 unit and disconnect all wiring. adapter. 2. Remove meter head bolts and lift meter head 4.
  • Page 8 Badger Meter, Inc. Due to continuous research, product improvements and enhancements, Badger Meter reserves the right to change product or system specifications without notice, except to the extent an outstanding contractual obligation exists. Please see our website at www.badgermeter.com...

This manual is also suitable for:

Er-10h

Table of Contents