Table of Contents
Advertisement
Swinging outwards
1. Activate the release lever A and swing the leg rests
to the outside.
Swinging forwards
1. Swing the leg rest forwards until it engages.
Unhinging
1. Activate the release lever A.
2. Pull the leg rest upwards.
Hinging
1. Hinge the leg rest on the front of the frame and swing it
forwards until it engages.
3.9.2 Swing away, angle adjustable leg rests
Swinging outwards
1. Activate the release lever A and swing the leg rests
outwards.
Swinging forwards
1. Swing the leg rest forwards until it engages.
Unhinging
1. Activate the release lever A, swing the leg rest outwards.
2. Pull the leg rest upwards.
Hinging
1. Push the leg rest down into its receiver and swing it
forwards until it engages.
Adjusting angle
There are six preset positions available for angle adjustment.
1653395-C
1. Rotate the knob D with one hand while supporting the
leg rest with your other hand.
2. When a suitable angle is obtained, let go off the knob
and the leg rest will lock into the desired position.
Swinging calf pad and adjustments
•
Swinging calf pad forwards (1) or backwards (2) :
1. Swing calf pad E forwards (1).
2. Pull up the calf pad E and swing it backwards (2).
•
Adjusting height of calf pad:
1. Loosen knob C.
2. Adjust to the desired height and firmly tighten the
knob.
•
Adjusting depth of calf pad
The calf pad has four depth adjustment options:
1. Remove the fixing screw F with 5 mm Allen key.
2. Adjust to one of the four positions and firmly
tighten the fixing screw F (3–5 Nm).
Adjusting foot plate
There are three different fold-up foot plates available.
•
Standard height-adjustable foot plates:
1. Loose the fixing screw B with 5 mm Allen key.
2. Adjust the height and let the screw catch one of
the recesses on the foot plate tube.
3. Tighten the fixing screw B (3–5 Nm) in the desired
position.
The distance between the lowest part of the
footrest and the ground must be at least 50 mm.
•
Depth-, Angle- (1) and Width- (2) adjustable foot plates:
1. Loosen the fixing screw G or H with 5 mm Allen
key.
2. Adjust the depth and angle positions and firmly
tighten the fixing screw G (12 Nm) or H (8–9 Nm)
in the desired position.
Product Overview
15
Advertisement
Table of Contents
