Mounting The Half Tray; Adjusting The Half Tray; Add A Half Tray Cushion; Posture Belt - Invacare Rea Clematis Pro User Manual

Manual wheelchair passive
Hide thumbs Also See for Rea Clematis Pro:
Table of Contents

Advertisement

Rea® Clematis® Pro

4.7.1 Mounting the half tray

Mounting the half tray
1. Insert the tube of the half tray A into the attachment
B under the arm pad.
2. Push on the push pin C and insert the ring D on the
tube A.
3. Release the push pin C.

4.7.2 Adjusting the half tray

A
1. Slide the half tray A forwards or backwards to adjust to
the required depth.
CAUTION!
Risk of discomfort
– When adjusting the depth of the half tray,
make sure not to squeeze the stomach of
the user.

4.7.3 Add a half tray cushion

A cushion for the half tray can be placed on the half tray in
order to have a softer surface for the arms and elbows.
A
1. Place the cushion for the half tray A on the tray.
2. Place the attachment straps B into the plastic buckle
and around the half tray A.
22
B
A
B

4.8 Posture belt

The wheelchair can be equipped with a posture belt. It
prevents the user from sliding downward in the wheelchair
or from falling out of the wheelchair. The posture belt is
not a positioning device.
WARNING!
Risk of serious injury / strangulation
A loose belt can allow the user to slip down and
create a risk of strangulation.
– The posture belt should be mounted by
a qualified technician and fitted by the
responsible prescriber.
– Always make sure that the posture belt is
tightly fitted across the lower pelvis.
– Each time the posture belt is used, check if it
fits properly. Changing the seat and/or backrest
angle, the cushion and even your clothes
influence the fit of the belt.
WARNING!
Risk of serious injury during transport
In a vehicle, a user in his wheelchair must be
secured by a safety belt (3-point belt). A posture
belt only is not sufficient as a personal restraint
device.
– Use the posture belt as a complement, but not
as a substitute to the 3-point safety belt, when
transporting the wheelchair user in a vehicle.
Closing and opening the posture belt
Ensure that you are sitting fully back in the seat and that the
pelvis is as upright and symmetrical as possible.
1. To close, push the catch A into the buckle clasp B.
2. To open, push the PRESS button C and pull the catch A
out of the buckle clasp B.
Adjusting the length
The posture belt has the good length, when there's
just sufficient space for a flat hand between body
and belt.
1653395-C

Advertisement

Table of Contents
loading

Table of Contents