Table of Contents
Advertisement
3. Re-tighten the screws.
4.
Remove the trunk support by loosening knob C and
pull the trunk support sideways and outwards.
Adjusting the swing-away arm
The holder C for the "swing-away" trunk support
only, is placed in the attachment A on the backrest.
1. Loosen the knob B.
2. Place the trunk support holder C.
3. Re-tighten the knob.
Tools: 5 mm Allen key / 13 mm fixed spanner.
1. The angle can be adjusted by loosening the screws E
and bolts D on the trunk support arm.
2. Hold with the Allen key and tighten with the fixed
spanner.
3. Remember to re-tighten the screws and bolts when the
required position is achieved.
The "swing-away" trunk support can be turned
sidewards in order to be out of the way when the
user is moving in to or out of the wheelchair.
CAUTION!
Risk of pinching
– The cover on the trunk support arm must
always be on when the chair is in use.
4.5 Adjusting the drip stand
WARNING!
Risk of tipping / injury
– Max. load on the drip stand: 4 kg (2 x 2 kg)
The rod of the drip stand must always be placed in
a vertical position, i.e. in a 90 degree angle to the
ground, no matter the position of the backrest or
the wheelchair.
1653395-C
Height
A
1. Loosen the lever A.
2. Adjust the drip stand to the desired height.
3. Firmly tighten the lever A.
Angle
A
1. Loosen the lever A.
2. Adjust to the desired angle.
3. Firmly tighten the lever A.
4.6 Table tray
WARNING!
Risk of falling / injury
– The table must never be used as a replacement
for the posture belt.
WARNING!
Risk of tipping / injury
– Max load on the table: 8 kg
Options
19
Advertisement
Table of Contents
