Advertisement
VIII. ASSEMBLY NOTES
As shown above, the fuselage is shipped in 2-pieces. Test fit, then use the supplied 4 composite rods
and epoxy to glue the front and rear parts of the fuselage together. You might need to shorten the 2
rods on top to clear the wing bolts and water rudder hatch on rear turtle deck. Make sure it is glued
strong and well-sealed against leaks.
Install water rudder and servo.
Install elevator (operated by 2 mini servos) and rudder (operated by one mini servo) and servos.
Guide the servo extensions through the fuselage and into the nose. Test fit then use the supplied
composite rod to glue the elevator to the vertical fin. Test fit and install the elevator "benches."
8
Page
of 14
Copyright 2016
S161222
Advertisement
