Validation Of The Installation - Smappee Infinity Install Manual

6.

Validation of the installation

Once the installation is complete, it is good practice to validate the correct operation of the
connection between the EVBox car charging station and the Smappee Infinity.
To validate the physical Smappee Infinity installation, please refer to the Smappee Infinity
manual. Pay extra attention to the following:
•
Check if the stickers on the CTs or CT Hubs correspond to the correct load
•
In the app, go to Settings – Your Smappee monitors – Load configuration and check
the values to see if they are logical
The procedure to verify the connection between the Smappee gateway and the EVBox
charging station depends on whether a Smappee Connect or Genius is used, as can be seen
below.
Smappee Connect
To check correct operation, verify that the LED is green breathing. If it is red
breathing if there is no valid connection with the EVBox charging station.
Smappee Genius
To check the correct operation, go to Control – All – Smart devices – the car
charging station you connected – Status should state Connected.
English – Version 1.2 – January 2021
18