Cisco Linksys WVC54GCA User Manual page 254

Installation
I.
The Wizard searches for the Wireless-G
Internet Home Monitoring Cameras on
your network, then displays the Camera
found along with status information .
If the Camera you want is not displayed,
click Search Again to run a new search
for Cameras .
Otherwise, in the Camera List box,
click the name of the Camera you are
currently installing . Write down the IP
address of the Camera, so you can use
it to access the Web-based Utility later .
Click Next .
J.
Enter a name for the Camera .
Memorable names are helpful,
especially if you are using multiple
Cameras on the same network . It
should have 15 characters or fewer .
After you have entered the name, click
Next .
K.
Select how to assign an IP Address to
the Camera, either automatically or
manually . Then click Next
Automatically obtain an IP
Address Select this option if you want
to automatically assign an IP address to
the Camera using DHCP . If you are not
sure which option to choose, Linksys
recommends this option .
Set IP address configuration
manually Select this option if you
want to manually assign a static IP
address to the Camera . If you select
this option, fill in the IP Address, Subnet
Mask, and Gateway fields .
4
.