Cisco Linksys WVC54GCA User Manual page 15

Chapter2
Placement Options
The Camera can stand on a surface or be mounted on a
wall . Depending on the positioning you want, you attach
the Camera head to its stand at two different points .
Stand Option
Follow these steps to stand the Camera on a surface .
1 . Insert the screw end of the stand into the hole on the
bottom panel .
2 . Tighten the screw and then the thumbscrew .
3 . Place the Camera, and adjust the tilt of its head
accordingly, as described below in section "Camera
Head Tilting" .
Camera in Standing Position
Wall Mount Option
You use the Camera's stand to mount the Camera on a
wall . The stand has two wall-mount slots that are spaced
58 mm apart .
1 . Insert the screw end of the stand into the hole on the
back panel .
2 . Tighten the screw end and then the thumbscrew .
3 . Determine where you want to mount the Camera .
Attach two screws to the wall, so that the Camera's
wall-mount slots line up with the two screws .
4 . Maneuver the Camera so the screws are inserted into
the two slots .
Wireless-G Internet Home Monitoring Camera
5 .
Thumbscrew
(tightened)
Camera Head Tilting
After the Camera is assembled, you can tilt the Camera
head on its ball joint using the lock nut on the camera
stand . Loosen the lock nut, tilt the camera head as desired,
then tighten the lock nut to secure the position .
Setting Up and Mounting the Camera
Adjust the tilt of its head accordingly, as described
below in section "Camera Head Tilting" .
Wall Mount Option
Camera in Wall-Mounting Position (side view)
58 mm
(2 .28 inches)
Wall-Mount Slots
Hole for Attaching Stand
(Wall-Mount Option)