Cisco Linksys WVC54GCA User Manual page 22

Chapter3
Setup Screen
The Setup screen is accessed by clicking the Setup button
on the Monitor window of the Camera Utility . There are
four tabs along the left side of the Setup screen: Network
Camera, Internet Camera, Recording Schedule, and
Preferences . By default, the Network Camera tab is
selected when the Setup screen is opened . These tabs
display screens whose functions are described below .
Setup > Network Camera
Click the Network Camera tab to set up a network Camera .
Setup > Network Camera
The upper section of the Setup > Network Camera screen
contains a list of all Wireless-G Cameras that have been
detected (up to 9) . The Camera Details section of the
screen provides information about the selected Camera .
Camera List
Enable Check this box to enable the Camera . Uncheck
the box to disable the Camera .
Camera Name Displays the name of the Camera .
IP Address Displays the Camera's IP address .
Port Number Displays the Camera's port number .
Motion Detection Recording
detection recording is enabled or disabled .
Camera Details
Camera Name
Displays the name of the Camera that you
specified while running the Setup Wizard .
MAC Address Displays the Camera's MAC address .
IP Address Displays the Camera's IP address .
Wireless-G Internet Home Monitoring Camera
Indicates if motion
Installing and Using the Camera Utility
Port Number Displays the Camera's port number .
User Name and Password
password is displayed as "•••••" for security reasons .
Enable Motion Detection
recording, check this checkbox . The default is disabled .
Click Advanced Configuration to open the Web-based Utility .
Click Save to save your changes, or click Exit to exit without
saving changes . Click Help to display help information .
Setup > Internet Camera
To set up a Camera located on the Internet, click the
Internet Camera tab, then fill in the fields and click Add .
Setup > Internet Camera
Camera Name Enter the name assigned to the Camera .
MAC Address Enter the Camera's MAC address .
IP Address Enter the Camera's IP address .
Port Number Enter the Camera's port number .
User Name and Password
and password .
Stream Type Select either MJPEG or MPEG (default) .
Enable Motion Detection Recording
enable motion detection recording . The default is disabled .
Add After you have entered all of the information for the
Camera, click this button to add the Camera to the list .
Advanced Configuration
Web-based Utility in your web browser .
Click Advanced Configuration to open the Web-based
Utility . Click Exit to exit without saving your changes . Click
Help to display help information .
Displays the user name . The
To enable motion detection
Enter the Camera's user name
Check the box to
Click this button to open the
1