Cisco Linksys WVC54GCA User Manual page 13

Chapter2
Enter the Static IP Address
11 . If you want to keep the Camera's default password
(admin), leave the fields unchanged and click Next .
If you want to change the password, enter the new
password, re-enter to confirm, then click Next .
Enter the Camera Password
12 . The Wizard will search for wireless networks, then list
the wireless networks found . If the wireless network
you want to connect to is not listed, click Refresh to
update the list . Select the wireless network that you
want to connect the Camera to, then click Next .
Select Wireless Network
Wireless-G Internet Home Monitoring Camera
Setting Up and Mounting the Camera
13 . The Wizard displays the wireless security method that
your network is using: WPA/WPA-Personal, WEP
(18-Bit), or WEP (6-Bit) . Follow the appropriate
instructions below . If you are not using wireless
security, select Disabled and go to step 14 .
• WPA/WPA-Personal Enter a passphrase in the
Passphrase field and click Next . The passphrase is case-
sensitive and must be from 8 to 63 characters in length .
Security Settings - WPA/WPA2-Personal
WEP (6-Bit) or WEP (18-Bit)
•
key automatically, enter a passphrase in the Passphrase
field and click Next . The passphrase is case-sensitive and
should not be longer than 16 characters . It must match
the passphrase of your other wireless network devices
and is compatible with Linksys wireless products only .
(If you have any non-Linksys wireless products, enter
the WEP key manually on those products .)
To manually enter a WEP key, leave the Passphrase field
blank, click Next, and enter the WEP key on the next
screen . This WEP key must match the WEP key of your
wireless network . For 64-bit WEP encryption, enter
exactly 10 hexadecimal characters . For 128-bit WEP
encryption, enter exactly 26 hexadecimal characters .
Valid hexadecimal characters are "0" to "9" and "A" to "F" .
After you have entered the WEP key, click Next .
Security Settings - WEP (64-Bit) or WEP (128-Bit)
To generate the WEP