PROAIM Spin Lightweight Doorway Dolly Assembly Manual page 2

Spin Dolly Setup

Loosen the knob on either rear side of dolly.
Insert both Handle Bar together & tighten the
knobs to secure them.

Insert push bar handle into Rear-Wheel
Steering and lock it with the provided pin.
Converting 4x4 Steering into 2x2

Hold hex nut with 13mm wrench & loosen the
steering rod bolt with 4mm allen key to
remove the allen bolt from dolly.

Then remove the bolt (as shown) with the
help of 10mm allen key and detach the front
section of dolly.

Remove bolts on Pneumatic wheels with
provided 4mm allen key and detach the
wheels.

Insert the wheel axle in dolly & screw it
tightly. Then attach the wheel and tighten it
properly.
2