Main Menu; Configure System; Manual Configure - Macurco DVP-1200 Manual

Macurco TM DVP-1200 Manual
3. A third zone also monitors the same sensors and turns on the last relay as a signaling device to a live monitor station,
as well as turning on an external horn and strobe.
In addition to controlling the relays based on the gas concentration, each zone can have a timed function, e.g. turn on low
volume ventilation fans at 7:00 AM and turn them off at 8:00 PM.

4.6 Main Menu

The Main Menu can be entered from normal mode by pressing the MENU key. The display will show the main menu as shown
below. All the DVP-1200 configuration menus are password protected. Default password for the panel is '1234'.

4.6.1 CONFIGURE SYSTEM?

Menu path: Main Menu/CONFIGURE SYSTEM? /
The DVP-1200 configuration can be changed manually. To enter the configuration menu, a password is required. While the DVP-
1200 is in configuration mode, alarm and ventilation control functions continue in the background with the previously set
configuration values. If an alarm, warning, or trouble condition is detected, the corresponding led, the buzzer, the horn and the
strobe will operate as configured and the display will switch to the corresponding status display.

4.6.2 MANUAL CONFIGURE?

Menu path: Main Menu-->CONFIGURE SYSTEM? -->MANUAL CONFIGURE? -->
Choose "MANUAL CONFIGURE?" to use the DVP-1200 interface to configure the system. Follow the menu as shown below to
enter the "MANUAL CONFIGURE?" menu.
FONFIGURE ZONES?
REV – 1.3.1
Figure 4-6 –
Figure 4-7 –
[34-8708-4770-7 ] 27 | P a g e