Table of Contents
Advertisement
Macurco
TM
DVP-1200 Manual
4 Operations
4.1 Power up
When power is applied to the panel, the DVP1200 will start up. During the startup sequence, the LED status lights will flash.
Once the POWER/TROUBLE light is steady green, the panel is ready to configure. If the panel is powered up for the first-time
screen like Figure 4-1 will show up. This screen will allow the installation company information to be entered and saved in the
control panel. This information can be accessed or changed via "TECHNICAL SUPPORT" in main menu. Select "MAIN MENU" and
hit ENTER to go to DVP-1200 Main Menu.
DVP-1200 may not function effectively below 32°F (0°C) or above 104°F (40°C). Using the equipment
outside of this temperature range may adversely affect product.
4.1.1 Initial Operating Mode
If the user has not entered any parameters, the system WILL NOT be controlling the ventilation system. The relays WILL NOT
actuate, and the horn and strobe outputs WILL NOT be powered.
4.2 User Interface
4.2.1 LCD Display
The LCD display is used to show detailed information about the status of the control system and the configuration parameters.
4.2.2 Status Lights
The POWER/TROUBLE, HUSH, WARNING/ALARM, RELAY status lights indicate the system status and provide the following data:
REV – 1.3.1
(feet)
(meters)
24
200
22
340
20
480
18
850
Table 3-4 –
WARNING
Figure 4-1 –
[34-8708-4770-7 ]
61
103
147
215
21 |
P a g e
Advertisement
Table of Contents
