Table of Contents
Advertisement
Macurco
TM
DVP-1200 Manual
6 Testing & Maintenance
6.1 Testing
6.1.1 Relay Functionality Test
a.
Access the Relay Configuration Menu (Refer to Section 4.6.3.1) and select the configuration for relay to be tested.
b. Change the "RELAY ON/OFF" to ON and save the configuration. This will activate the corresponding relay and
normally open connections will be closed.
c. Once the test is complete, change the configuration back to desired settings and save it.
6.1.2 Horn and Strobe Functionality Test
a.
Access the Horn/Strobe Configuration Menu (Refer to Section 4.6.3.3) and select the configuration for Horn/Strobe
to be tested.
b. Change the "HS ON/OFF" to ON and save the configuration. This will activate the device connected to
corresponding Horn/Strobe.
c. Once the test is complete, change the configuration back to desired settings and save it.
REV – 1.3.1
Figure 7-1 –
Figure 7-2 –
[34-8708-4770-7 ]
57 |
P a g e
Advertisement
Table of Contents
