Flavel Rocco HE FPHL RN2 Series Installation, Maintenance & User Instructions page 40

5.9 REMOVING / RE-FITTING THE GLASS FRAME ASSEMBLY
5.9.1 The glass frame is held in position by hooking the top flange over the
combustion chamber opening at the top as shown in figure 12 below.
Fig. 12
Glass Frame Assembly
locates over lip on top of
combustion chamber lid, and
drops onto flange as shown.
To remove, unclip base clips
as shown in figure 13 and lift
clear.
denotes correct
final position of
glass frame.
5.9.2 The assembly is then secured to the bottom of the combustion chamber
by the two hinge clamp brackets as shown below in figure 13. These
are clamped together to form the seal between the glass frame
assembly and the combustion chamber.
Fig. 13
Combustion
Chamber
40