Product Lifespan - Spanset Excel Instructions Manual

INSPECTION AND EXAMINATION
Keep these instructions, or a copy with the belt to aid future
inspection, and examination.
The equipment must be given a visual and tactile inspection
when delivered to site/works, and before every use.
Current European standards state that at least every 12
months PPE should be inspected by a competent person,
and theresults recorded. SpanSet recommends recorded
inspection by a competent person every 4 months.
Particular attention should be paid to the following:-
Metal-ware: Inspect for signs of damage/distortion/
corrosion, and correct operation & locking of
connectors.
Stitching: Look for broken stitch, loose or worn
threads.
Examine for any signs of fading/wear/
Webbing:*
abrasion, including inter-strand wear,
unravelling, extension and fusion.
* Local abrasion as distinct from general wear may be
caused by contact with sharp edges or protrusions while in
use and maycause serious loss of strength. Slight damage
to outer fi bres and occasional yarn may be considered
harmless but anyreduction in width or thickness of the
webbing or serious distortion to the weave pattern should
lead to rejection.
All Personal Protective Equipment should be immediately
removed from service after being subjected to any shock, or
there isany doubt about its condition. (See list above)
The belt may be cleaned if required. The following
procedure must be adhered to. Use a mild detergent with
hand hot water, using a cloth, or sponge to wipe the belt
and avoid over wetting. This procedure should then be
repeated with clean water torinse, and then allowed to dry
naturally away from any direct heat source. If you require
more information please contact SpanSet.
All equipment should be stored and transported in the
following manner:
- To prevent contact with sharp objects.
- Away from harmful substances.
SpanSet Excel
Work Positioning Belt

PRODUCT LIFESPAN

It is mandatory by European Law that all PPE must be
supplied with comprehensive User Instructions which detail
the lifespan of the product, and the inspection requirements.
The actual frequency of the periodic inspection is the
responsibility of the competent person in charge of the
maintenance of the product. Aggressive or arduous
conditions and constant use will potentially reduce the
working life of the product and so a more frequent inspection
regime will be required to effectively monitor this.
SpanSet recommend that PPE for Work at Height is
thoroughly examined by a competent person:
- Periodically at intervals not exceeding 6 months
- Interim inspections where required
SpanSet recommend that Pre Use inspection is carried out by
the user before each and every use. Any concerns about the
condition of equipment must result in the item undergoing a
thorough interim inspection.
The equipment should only be used if it is found to be in a fi t
condition.
In addition SpanSet give this product a period of
obsolescence of 10 years from date of manufacture, even if
never used.
Products should be withdrawn from service if they meet any
one of the following criteria:
1) Failure of a thorough examination
2) Subjected to or Used to arrest a fall
3) Manufacturers period of obsolescence (shelf-life) has
been reached
Compatibility and use of PPE is the responsibility of the user.
SPANSET TRAINING
SPANSET offers training either on site or at our own
premises, in all aspects of height safety. Courses are
accredited under ourregistration to ISO 9001, and
certifi cates are issued on successful completion.
Although it is not compulsory, for the safety of all users
SPANSET recommends you take advantage of this training
service, please contact us for further details.
3