Connecting The Hardware - Axis 5570e User Manual

AXIS 5570e and AXIS 5670e User's Guide

Connecting the Hardware

Follow these instructions to make your printer network ready:
1. Switch off the printer(s) and disconnect the AXIS 5570e/AXIS 5670e external power supply.
2. Locate the serial number, found on the backside label of the print server, and write it down.
You will need this number during the network configuration.
3. Connect the print server to the printer(s).
4. Connect the print server to the network using a twisted pair RJ45 cable (of category 5 or
better).
5. Switch on the printer(s) and connect the external power supply to the AXIS 5570e/AXIS
5670e. The power indicator lights up. If the network indicator starts to flash, the print server
is correctly connected to the network.
6. Press and release the test button on the print server to print a test page.
If the print server is correctly connected to the printer(s), a test page will be printed.
Mounting the AXIS 5570e
Using the supplied clip and holder, your AXIS 5570e can be mounted in many ways, e.g. on the
back of the printer or on a wall.
Adhesive Clip
Adhesive Holder
Proceed to Setup and Configuration on page 12 to determine which setup procedures that are
relevant to your network environment.
Fasten to print server by peeling off adhesive tape.
Fasten to mounting surface by peeling off adhesive tape.
11