38
Verifying the Communication Link
Follow the instructions below to verify communication from the AXIS 5570e/AXIS 5670e to the
Mainframe host via the SNA Server:
1. Activate the connection you created in step 2 of the above
connection
5670e
2. Make sure the corresponding LU in the host is activated.
3. Activate the TN3270 connection to the AXIS 5570e/AXIS 5670e. The LUA should change
status to SSCP.
4. Send a print job from the host.
Note:
You can check the status of the TN3270E connection by printing a test page from the print server. This is done
by pressing the test button once. Make sure the TN3270E status (St:) line for your server connection is defined
as either:
- SSCP
- LU-1
- LU-3
Important!
If the setup fails, please refer to the troubleshooting section in the AXIS 5570e/AXIS 5670e User's Manual, on
www.axis.com
Proceed to Print Server Management and Configuration on page 56 for information on supported
management and configuration tools.
procedures. The status of the connection should be "active".
AXIS 5570e and AXIS 5670e User's Guide
SNA Server -
AXIS 5570e/AXIS