Axis 5570e User Manual page 19

AXIS 5570e and AXIS 5670e User's Guide
8. Type DSPSYSVAL QAUTOCFG and press Enter. Check that the parameter is set to
ON(1). Press F3.
9. Type DSPSYSVAL QAUTORMT and press Enter. Check that the parameter is set to
ON(1). Press F3.
10. Type DSPMODD QRMTWSC on the command line to check that the mode description
exists on the system. Press F3. Refer to the AXIS 5570e/AXIS 5670e User's Manual for
information regarding the QRMTWSC mode.
11. Type DSPUSRPRF QUSER. Make sure that the QUSER Status is *ENABLED and has its
Maximum Storage Allowed parameter set to *NOMAX. Press F3.
12. Use the command WRKCFGSTS *CTL xxxx*, where xxxx are the first 4 characters of
the AXIS 5570e/AXIS 5670e LU Name, to delete any previously created Controller and
Device descriptions specific to your AXIS 5570e/AXIS 5670e. Delete the Device Descriptions
(indented text) first and then the Controllers. (You will find the print server's LU Name in the
Parameter List, under SNA menu. Press the print server's test button twice to print the
Parameter List.)
If you experience problems with the installation procedure, please refer to the AXIS
5570e/AXIS 5670e User's Manual on www.axis.com
19