Table of Contents
Advertisement
Cleaning and care
Cleaning the plinth filter
Clean the filter thoroughly under
running water.
Squeeze the plinth filter carefully
several times as you rinse it.
Rinse the plinth filter until all visible
residues have been removed.
A fault may occur.
The plinth filter must not be replaced
dripping wet.
Damage caused by an
insufficiently cleaned or damaged
fluff filter.
If the filter has not been properly
cleaned or is damaged, the heat
exchanger will be clogged. There will
be an insufficient flow of air and heat
exchange in the heat exchanger. This
requires a visit from a Miele service
technician.
Before and after cleaning, check the
plinth filter in accordance with the
description in "Replacing the plinth
filter". The plinth filter must be
perfectly functional and undamaged
after cleaning.
42
Use a damp cloth to remove any fluff
from the handle.
Replacing the plinth filter
Filter wear caused by continuous
tumble dryer use.
If the tumble dryer is in continuous
use and is being cleaned frequently,
the plinth filter can begin to show
signs of wear after a while. This can
clog up the heat exchanger.
Replace the filter immediately
(replacement filters are available as
an optional accessory) if you see the
following signs of wear before or
after cleaning.
Advertisement
Table of Contents
