Table of Contents
Advertisement
In the event of a fault and for cleaning purposes, the tumble dryer
must be disconnected from the electricity supply. It is only
completely disconnected when:
- it is switched off at the wall socket or the plug is withdrawn, or
- the mains fuse is disconnected, or
- it is switched off at the mains circuit breaker.
For further information see "Installation - Electrical connection".
This tumble dryer must not be installed and operated in mobile
locations (e.g. on a ship).
Please observe the instructions in "Installation" and "Technical
data".
The electrical socket must be easily accessible so that the tumble
dryer can be disconnected from the electricity supply.
If the appliance is hard wired, adequate provision must be made
on site to switch off all poles to disconnect the tumble dryer from the
electricity supply. The means of disconnection must be incorporated
in the fixed wiring in accordance with the wiring rules.
The gap between the bottom of the tumble dryer and the floor
must not be blocked with plinth facings, deep pile carpet etc., which
would obstruct the openings. This would hinder a sufficient flow of
air to the tumble dryer.
The appliance must not be installed behind a lockable door, a
sliding door or a door with a hinge on the opposite side to that of the
tumble dryer, in such a way that a full opening of the tumble dryer
door is restricted.
This tumble dryer is supplied with a special lamp to cope with
particular conditions (e.g. relating to temperature, moisture, chemical
resistance, abrasion resistance, and vibration). This special lamp
must only be used for the purpose for which it is intended. It is not
suitable for room lighting. Replacement lamps may only be fitted by
a Miele authorised technician or by Miele Professional Service.
Warning and Safety instructions
9
Advertisement
Table of Contents
