Cleaning The Fluff Filters With Water; Cleaning The Plinth Filter; Removing The Plinth Filter - Miele TWV 780 WP Operating Instructions Manual

 Use a vacuum cleaner with a long
crevice nozzle attached to remove any
visible fluff from the upper air flow
openings.
Finally, clean the fluff filters with water.

Cleaning the fluff filters with water

 Wipe the smooth plastic surfaces of
the fluff filters with a damp cloth to
clean them.
 Flush the filters through under warm
running water.
 Shake the fluff filters thoroughly and
then dry them carefully.
Ensure the filters are dry before re-
placing them. Wet filters could cause
operational faults.
 Push the lower fluff filter in com-
pletely and lock it with the yellow dial.
 Push the upper fluff filter in com-
pletely.
 Close the door.

Cleaning the plinth filter

Clean the plinth filter when the pro-
gramme running time is longer than
usual or if the following message lights
up in the display:
plinth filters. See the operating instruction
manual for more information.
 To clear the message, confirm with
.
OK
Clean the fluff and
Cleaning and care

Removing the plinth filter

 Press the round, indented area on the
heat exchanger access panel to open
it.
The panel will spring open.
 Pull the plinth filter out by the handle.
The right-hand guide pin comes out
when the plinth filter is removed. The
guide pin prevents the access panel
from closing without the plinth filter.
57