Axis Q6035 User Manual page 53

AXIS Q6035 PTZ Dome Network Camera
Troubleshooting
Missing images in uploads
Slow image update
Poor performance
Poor quality snapshot images
Screen incorrectly
configured on your computer
Overlay image is not displayed
Incorrect size or location of
overlay image
Privacy mask is not displayed
Incorrect size or location of
privacy mask
Browser freezes
Netcape 7.x and Mozilla 1.4
(or later) can sometimes
freeze on a slow computer
Problems uploading files
Limited space
Motion Detection triggers unexpectedly
Changes in luminance
No audio
Incorrect setup
No audio or very poor audio
quality
Poor audio quality
CPU overloaded
Unsynchronized audio and
video
Distorted audio
Feedback loops
Storage and disk management problems
Video cannot be recorded
SD card cannot be mounted
This can occur when trying to use a larger image buffer than is actually available. Try lowering
the frame rate or the upload period.
Configuring pre-buffers, motion detection, high-resolution images or high frame rates will affect
the performance of the Axis product.
Poor performance may be caused by heavy network traffic, multiple users accessing the product,
low performance clients, use of features such as motion detection and event handling.
Configure your screen to show at least 65000 colors, that is, at least 16 bits. Using only 16 or 256
colors will produce dithering artifacts in the image.
The overlay image may have been positioned incorrectly or may be too large. See
Settings
in the online help for more information.
The privacy mask may have been positioned incorrectly or may be too large.
Lower the image resolution
There is only limited space available for the upload of your own files. Delete existing files to free
up space.
Motion detection is based on changes in luminance in the image. This means that if there are
sudden changes in the lighting, motion detection may trigger mistakenly. Lower the sensitivity
setting to avoid problems with luminance.
Check the sound card in the computer. Ensure that mute is not selected and that the volume
settings are correct.
Check that Enable audio support is selected under Setup > System Options > Security > Audio
Support.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Reduce the number of listeners and viewers. Decrease image resolution and compression.
Synchronize the product's date and time settings with an NTP server. Go to Setup > System
Options > Date & Time.
Check that the correct Audio Input source is selected under Setup > Video & Audio > Audio
Settings.
Feedback loops might appear in full-duplex mode. Try moving the microphone or the speaker, or
use half-duplex mode instead.
Check that the SD card is not write protected (that is, read only).
Reformat the SD card and then click Mount.
53
Overlay Image