Taring; Hold Function - KERN MPS200K100NM Operating Instructions Manual

9.2 Taring

The dead weight of any initial load used for weighing may be tared away by pressing
the key, so that the following weighing shows the real weight of a person to be
weighed.
 E.g. when a rubber mat is put on the scale plate, the scale does not
show 0 value.
 To start the taring process, press the [TARE] key. Now internal weight
saving is performed and value of 0.0 kg is displayed.
 Place a person in the middle of the scale plate.
 Then read the weight on the display.
Direction:
The scale can store only one tare value.
When the scale is unloaded, the saved tare value is displayed with „negative" sign.
To delete the saved tare value, unload the scale plate and then press the [TARE]
key.

9.3 HOLD function

The scale is provided with the integrated hold function (determination of average val-
ue). It enables people to be weighed accurately although they are not still on the
scale plate.
Note: Determination of average value is not possible when a person moves too
much.
 Switch on the scale with the [ON/OFF] key. The diagnostic scale self-check is
performed. The scale is ready for weighing when the „0.00 kg" weight display
is shown.
 Place a person in the centre of the scale plate.
 Press the [HOLD] key. When the triangle is flashing on the display, the scale
takes some measuring values and then the calculated average value is dis-
played.
 Press the [HOLD] key again to return the scale to the normal weighing mode.
 Pressing the [HOLD] key makes it possible to activate the function at any
time.
MPS / MTS / MXS / MWS-BA-e-1621 47