Grounding The Pump - Graco Fast-Flo 226-943 Instructions-Parts List Manual

For automatic air motor lubrication, install an air line
lubricator (C) downstream from the air regulator (if sup-
plied) and all other accessories. Install a bleed-type
master air valve ( D ) close to the pump. Next, install the
air regulator (CCI, if supplied. Install an air line filter (E)
dirt and moisture from the compressed air supply.
upstream from all other accessories, to remove harmful
Using
a
suitable adapter, install the male disconnect pin
fitting
(J)
in the air filter inlet. Install the air line quick
disconnect coupler (L) on the air hose (F), but do not
connect it to the pin fitting yet.
fluid outlet.
Connect
a
grounded fluid hose
(M)
to the 314 npt(f)
Valve Kit Installation (Models 226-949 and 226-950
only)
Using 'thread sealer on the male threads of the street
tight and the dispensing valve (BB) is in the position
elbow (AA), screw it into the pump fluid outlet (HI until
shown in Fig 2.
Using moderate force only, extend the pump suction
tube, insert the pump into the drum or tank bung hole,
and screw the bung adapter (B) tightly into the bung
hole. Lift the pump about 12 mm (0.5 in.) and tighten
the bung adapter (6) screw to hold the pump. Loosen
the vent plug (A). Refer to Typical Installation on page
3.
MODEL
SHOWN
1 - C A U T I O N
To prevent damaging the O-ring
- 1
seals inside the
Fig 2
suction tube, do not use excessive force when ex-
tendina the suction tube.
Grounding the Pump
Ground the pump and all other system components
as
instructed in FIRE OR EXPLOSION HAZARD on page
2.
4
307-427