Graco 226290 Instructions-Parts List

Hand rotary transfer pump

Download this manual

Instructions - Parts List

Hand Rotary

Transfer Pump

Used to transfer petroleum-based and synthetic oils, and non-corrosive chemicals. For

professional use only.

Model 226290

Delivery Rate: 1 gallon (3.7 l) per 18 cycles

Bung nut fits 2 inch (50.8 mm) bung hole.

Includes a 42 inch (1066.8 mm) suction tube.

Important Safety Instructions

Read all warnings and instructions in this

manual. Save these instructions.

306876J

Need help?

Do you have a question about the 226290 and is the answer not in the manual?

Page 1 Transfer Pump Used to transfer petroleum-based and synthetic oils, and non-corrosive chemicals. For professional use only. Model 226290 Delivery Rate: 1 gallon (3.7 l) per 18 cycles Bung nut fits 2 inch (50.8 mm) bung hole. Includes a 42 inch (1066.8 mm) suction tube.
Page 2 Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclama- tion point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable.
Page 3 Installation Installation the bung nut opening and allow it to rest against the Grounding bottom of the drum. Tighten the bung nut set-screw against the suction pipe. 3. Before pumping, make sure there is an open air The equipment must be grounded to reduce the risk vent in the tank or drum.
Page 4 With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.