Hook "Certificate; Suspension Hook - Verlinde STAGEMAKER COMPACT SM1 Installation & Maintenance Manual

8-5 Hook « certificate »
Load FEM Test
capacity group load
(kg) (kg)
630 2 m 1260
1000 1 Bm 2000
1250 2 m 2500
2000 1 Bm 4000
Mark: ISO 2766
DIN model number: 15401

8-6 Suspension hook

REMOVAL:
1. Remove the screw and the locking plate.
2. Remove the two pins.
3. Take the hook out.
REPLACEMENT:
1. Put the hook into its housing.
2. Place the two pins inside the hook
3. Fit the screw and the locking plate without
forgeting the safety washer.
(Refer to paragraph 10-4 for the tightening torque).
Note: The hook should be set depending on 1/1
and 2/1 revings.
8-7 Measurement of the wear on the suspension and lifting hooks
The wear on the suspension and lifting hooks (dimension a2 and 32.5- see drawing at top of page) should be checked
regularly.
Damaged safety catches should be replaced immediately.
If the maximum dimension (a2) on the lifting hook is greater than the initial dimension by more than 15%, the hook should be
replaced immediately.
•
Bottom hook
Class: 025
a2, max. allowed: 30 mm
•
top hook
maximum allowed for the throat opening ( dimention )32.5mm ):
If it found to be worn please contact an authorised agent.
Number Minimum Marking
of falls ruin load Class
(kg)
1 3970 025 T
1 5000 025 T
2 7875 05 T
2 10000 05 T
DIN 15400 class: T
DIN 15401 material: 35 CD 4
05
39 mm
Ø M Ø a1 a2
16 36 26
16 36 26
20 43 34
20 43 34
37mm
9807/ 8.4
Dimensions
(mm)
a3 b1 b2 e1 h1
41 22 19 96 28
41 22 19 96 28
49 29 24 105 37
49 29 24 105 37
h2 t1 t2
24 38 13
24 38 13
31 43 14
31 43 14