Converting Ers 4850 To Vsp 4000; Ers 4850 And Vsp 4000 Quick Conversion - Extreme Networks ExtremeSwitching Virtual Services Platform 4850GTS Series Installation Manual

Installing the VSP 4000 4850GTS Series
Figure 2: VSP 4850GTS-PWR+
1. VSP 4000 USB device with USB device cover
Caution:
To ensure proper operation, the USB FLASH drive must remain inserted in all models of VSP 4850
(factory built and converted from ERS 4850), with the cover installed for additional protection against
removal. The USB FLASH drive on the VSP 4850 switch is uniquely bound to the system it was first
used on and cannot be transferred to a different switch.
2. Switch LEDs
3. 10/100/1000 Mbps PoE+ ports (LEDs above ports)
4. Combo 100/1000 Mbps SFP slots. Supports Extreme Networks 1G SFPs and 100 Mbps low-speed SFPs.
5. 1/10 Gbps SFP+ slots. Supports Extreme Networks 1 Gbps SFPs and 10 Gbps SFP+s.
6. Console port

Converting ERS 4850 to VSP 4000

This section lists information on Extreme Networks switch conversion supported in this release.
Important:
Switch conversion is applicable only to the Virtual Services Platform 4000 Series. Currently, only
the conversion of an ERS 4850 switch to a VSP 4000 switch is supported.

ERS 4850 and VSP 4000 quick conversion

Note:
ERS 4850 and VSP 4000 conversion kit (part number EC4810003–3.0) has reached End-Of-
Sale; however, it is still supported for anyone who has purchased it.
You can convert an ERS 4850 switch to a VSP 4000 switch, if there is a network requirement.
August 2018 Installing Virtual Services Platform 4850GTS Series 18