Extreme Networks ExtremeSwitching Virtual Services Platform 4850GTS Series Installation Manual page 17

VSP 4850GTS series models
The VSP 4850GTS series models consist of:
• 48 10/100/1000 Mbps ports
- RJ45 for the VSP 4850GTS and VSP 4850GTS DC models
- 802.3at PoE+ for the VSP 4850GTS-PWR+ model
• Two Combo 1000/1000 Mbps SFP ports
- These ports support copper and fiber on the same switch port. Only one medium type can
be active at any time.
- There is an RJ45 connector and an SFP slot for each Combo port. A cable can be inserted
into either or both medium types.
- Fiber connections take precedence over copper.
- Configuration for the port is applicable to both medium types. For example, auto-negotiation
configuration applies to both the copper and fiber ports.
• Two 1/10 Gbps SFP+ ports
Figure 1: VSP 4850GTS
1. VSP 4000 USB device with USB device cover
Caution:
To ensure proper operation, the USB FLASH drive must remain inserted in all models of VSP 4850
(factory built and converted from ERS 4850), with the cover installed for additional protection against
removal. The USB FLASH drive on the VSP 4850 switch is uniquely bound to the system it was first
used on and cannot be transferred to a different switch.
2. Switch LEDs
3. 10/100/1000 Mbps ports (LEDs above ports)
4. Combo 100/1000 Mbps SFP slots. Supports Extreme Networks 1 Gbps SFPs and 100 Mbps low speed
SFPs.
5. 1/10 Gbps SFP+ slots. Supports Extreme Networks 1 Gbps SFPs and 10 Gbps SFP+s.
6. Console port
August 2018 Installing Virtual Services Platform 4850GTS Series
Installation fundamentals
17